How every flash works:
1. Plug ONE board into your phone with the USB cable.
2. Tap the big button for the board in your hand.
3. When Chrome asks, pick the board in the list (it shows as CP2102).
4. If it sits at “Connecting” and will not move: hold the board’s BOOT button down, tap EN once, keep holding BOOT until the bar starts moving, then let go.
5. Wait for “Installation complete.” Unplug. Done with that board.
FLASH FIRST
SEED B · SATELLITE
One of the two bare boards. After this flash it never needs the phone again, only USB power from any charger.
This browser cannot flash boards. Open this page in Chrome on your phone.This page must be opened over HTTPS to flash.
FLASH SECOND
SEED C · SATELLITE
The other bare board. Same code as B, different name tag, so the collector can tell the two apart.
This browser cannot flash boards. Open this page in Chrome on your phone.This page must be opened over HTTPS to flash.
FLASH LAST
SEED A · COLLECTOR
The board that has been living on your phone cable (the one in the white breadboard). It watches with its own ears and gathers B and C’s reports into one screen.
This browser cannot flash boards. Open this page in Chrome on your phone.This page must be opened over HTTPS to flash.
Order matters only for watching: B and C can be flashed in any order, A last, because A is the one whose screen shows the whole room.
Flashing erases whatever code the board was running.
That is expected here; this installer is the new standard load for all three Seeds.